Johnny 5 is ALIVE!!! new head by Shawn added

This is not a true J5 head it is a remix that is based off other other models and CAD files. There are sections that need to be glued together to make printing it easier and faster.

It has three standard 35KG servos to rotate and tilt the head. It also uses six HS-40 servos for the eye flaps and one MG90 servo for the radar sensor.

The neck has a bearing the same type we use in the rest of the XR1 joints.

I have installed the same two cameras as the OG head uses along with the mic array and neck dampers.

I have also install a 4 port USB hub, Arduino Nano, PCA9685 16 port servo driver board and audio amp.